Honda GX240RT2 Service And Repair Manual page 319

CHARGING SYSTEM
CHARGE/POWER COIL REMOVAL/INSTALLATION
(*) Refer to page of base shop manual (iGX270UT2·iGX390T2/UT2 Supplement Y)
(**) Refer to page of base shop manual (GX240·GX270·GX340·GX390)
Remove the following:
– Fan cover (page 5-2*)
– Ignition coil (page 9-3*)
– Starter motor (page 10-8*)
– Flywheel (page 8-7**)
Installation is in the reverse of removal.
When installing the cord clamp, refer to HARNESS AND TUBE ROUTING (page 2-5).
QZX4, QZA2, QZAV types:
CORD CLAMP
BOLT (6 x 12 mm)
iGX240UT2:
BOLT (6 x 28 mm) (2)
iGX340UT2:
BOLT (6 x 40 mm) (2)
POWER COIL
iGX240UT2 QZX4 type:
BOLT (6 x 25 mm) (2)
iGX240UT2 QZA2, QZAV types:
BOLT (6 x 32 mm) (2)
iGX340UT2 QZX4 type:
BOLT (6 x 35 mm) (2)
iGX340UT2 QZA2, QZAV types:
BOLT (6 x 40 mm) (2)
QZX4 type:
0.9 A CHARGE COIL
QZA2, QZAV types:
2.9 A CHARGE COIL
8-4
gx240ut2_gx270ut2_gx340ut2_gx390ut2
CORD GROMMET
BOLT (6 x 12 mm)
CORD CLAMP
CORD GROMMET