Scale Name; Unit Of Weight; Gross Identifier - Siemens SIWAREX WP251 Manual

Scale parameters and functions
8.3 DR 3 Calibration parameters
Parameter
SecureDisplay version
(Page 75)
Smallest zoom factor of
SecureDisplay (Page 75)
Reserve
Reserve
Reserve
Reserve
Reserve
Reserve
Grid frequency (Page 75)
8.3.2

Scale name

You can select any name, but it may not exceed 12 characters. You can enter any
designation.
Note
The scale name cannot be changed after official verification.
8.3.3

Unit of weight

The following weight units are available for selection: milligram, gram, kilogram, metric ton,
ounce, pound, short ton, and long ton The weight unit selection has no effect on the internal
weight calculation. It involves only ASCII characters. Thus, all parameters with weight must
be specified with appropriate conversion when there is a change of weight unit.
8.3.4

Gross identifier

The gross identifier specifies the letter, B (for brutto) or G (for gross) to be used in the
display for a gross weight value.
66
Description Format
SecureDisplay version UBYTE
Minimum zoom factor USHORT
of SecureDisplay (%)
Reserve FLOAT
Reserve FLOAT
Reserve FLOAT
Reserve USHORT
Reserve USHORT
Reserve USHORT
Switchover of line USHORT
frequency 50/60 Hz
0: 50 Hz
1: 60 Hz
Length De- Min
[bytes] fault
12 "V3.0 -
0.10 "
2 0 -
4 0 -
4 0 -
4 0 -
2 0 -
2 0 -
2 0 0
2 0 0
Max Write Modbus
protec- holding
tion register
- - 1069
- - 1075
- - 1076
- - 1078
- - 1080
- - 1082
- - 1083
1 - 1084
1 - 1085
SIWAREX WP251
Manual, 12/2015, A5E37203357A