Siemens SIWAREX WP251 Manual page 113

Variable
Behavior in
case of TH1
error
(Page 116)
SIWAREX WP251
Manual, 12/2015, A5E37203357A
Note Data type
0: Weighing cycle is USHORT
not stopped and is
completed with
"Dosing completed"
1: Weighing cycle is
stopped. User can
use the "Continue"
command to check
the tolerance again
and the cycle is then
completed with
"Dosing completed"
in any case.
2: Weighing cycle is
stopped. User can
use the "Continue"
command to check
the tolerance again.
If there is still a tol-
erance error, the
scale goes to Stop
state again. This is
repeated until the
tolerance error is
eliminated (e.g. by
manually adding or
removing material).
Scale parameters and functions
8.21 DR 22 Tolerance parameters
Length RW De- Min
(bytes) fault
2 rw 0 0
Max Modbus
registers
0 1659
113