Data And Command Errors - Siemens SIWAREX WP251 Manual

Technology errors
2114 Maximum corrective action
exceeded
2115 Log error
2116 Set point too large
Reserve
Reserve
Reserve
Reserve
2096 Restore point set
2097 Restore point loaded
2098 Standard parameters
loaded
2099 Factory settings loaded
9.6.3

Data and command errors

Table 9- 2 Data and command errors
Data and command errors
5000 Data/command errors 5000
6050 Unknown command
6051 Command not possi-
ble now
6052 Service command
error
SIWAREX WP251
Manual, 12/2015, A5E37203357A
Error code Additional
string
-
6050 -
6051 -
4500
4501
4502
4507
4514
4541
4680
4681
6052
4510
4511
4507
4512
Error code Description and remedy
2114 The corrective active of the controller was greater than
the maximum corrective action configured in DR 24.
2115 Error while reading a log in DR 46.
2116 The set point specified in DR 20 is greater than the
residual quantity on the scale (removal mode). Weigh-
ing can still be carried out using the "Continue weigh-
ing" and subsequent "Rest emptying" commands!
Reserve Reserve
Reserve Reserve
Reserve Reserve
Reserve Reserve
2096 A recovery point was successfully set
2097 A recovery point was successfully loaded
2098 The standard parameters were successfully loaded
2099 The factory settings were successfully loaded
Description
Group error, at least one data/operating error present
Issued command code is unknown. Check the command code.
The desired command could not be executed because, for exam-
ple, another process is already active at this time. Additional
information contains details.
, because a fault is present
, because no standstill occurred
, because module is already waiting for standstill
, because dosing active
, because CPU is missing or not ready
, because emptying active
, because SecureDisplay is missing or not visible
, because display command does not match the current display
content
Commands from the Service commands group could not be exe-
cuted. Additional information contains details.
, because service mode is not active
, because write protection active
, because dosing active
, because enable missing
Errors and messages
9.6 Operating errors
167