Activate Service Mode; Load Standard Parameters; Image 7-2 Quick Calibration With Marked Parameters; Image - Siemens SIWAREX WP251 Manual

Image 7-2

Quick calibration with marked parameters
7.3.2

Activate service mode

Service mode must be activated in order to change the calibration parameters. You can find
the command in the "Service Commands" group (spanner icon).
7.3.3

Load standard parameters

The quick setup is based on the standard settings of the weighing module. Therefore, the
standard parameter settings must be reset prior to the quick setup. Firstly, service mode is
activated; the standard parameters are subsequently loaded using the "Load standard
parameters (12)" command.
The parameters must then be read from the SIWAREX in SIWATOOL using "Communication
→ Receive all data".
SIWAREX WP251
Manual, 12/2015, A5E37203357A
7.3 Automatic quick calibration with SIWATOOL
Commissioning
43