Bgp (Evpn) - Cisco ASR 9000 Series Reference Manual

Provider Backbone Bridge Commands

bgp (EVPN)

To enable Border Gateway Protocol (BGP) in the PBB EVPN configuration, use the bgp command in the
EVPN configuration or EVPN EVI configuration mode. To disable the BGP configuration, use the no form
of this command.
bgp [rd]
bgp [rd | route-target ]
no bgp
Syntax Description
rd
route-target
Command Default
None.
Command Modes
EVPN configuration
EVPN EVI configuration
Command History
Release
Release 4.3.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The keyword route-target is supported only in the EVPN EVI BGP configuration.
Task ID
Task ID
l2vpn
Examples This example shows how to enable BGP in the EVPN configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# evpn
RP/0/RSP0/CPU0:router(config-evpn)# bgp
RP/0/RSP0/CPU0:router(config-evpn-bgp)#
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
Sets the Route Distinguisher.
Sets the Route Target.
Modification
This command was introduced.
Operation
read, write
bgp (EVPN)
6.1.x
389