Cisco Asr 9000 Series Aggregation Services Router Vpn And Ethernet Services Command Reference, Release - Cisco ASR 9000 Series Reference Manual

show ethernet ring g8032
Examples
This example shows the output of the show ethernet ring g8032 command:
RP/0/RSP0/CPU0:router# show ethernet ring g8032 status
Ethernet ring Subring instance 1 is RPL Owner node in Protection state
Port0: Bundle-Ether100 (Monitor: Bundle-Ether100)
Port1: GigabitEthernet0/0/0/38 (Monitor: GigabitEthernet0/0/0/38)
APS Level: 7
Open APS ring topology
Profile: timer-wtr (not defined)
Ethernet ring Subring-2 instance 1 is RPL Owner node in Idle state
Port0: GigabitEthernet0/0/0/33 (Monitor: GigabitEthernet0/0/0/33)
Port1: GigabitEthernet0/0/0/3 (Monitor: GigabitEthernet0/0/0/3)
APS Level: 7
Open APS ring topology
Profile: timer-wtr (not defined)
RP/0/RSP0/CPU0:router#
RP/0/RSP0/CPU0:router# show ethernet ring g8032 brief
Wed Mar 16 07:14:28.719 UTC
R: Interface is the RPL-link
F: Interface is faulty
B: Interface is blocked
FS: Local forced switch
MS: Local manual switch
RingName
--------------------------------------------------------------------------------
Subring
Subring-2
RP/0/RSP0/CPU0:F4-2-A9K#
RP/0/RSP0/CPU0:router# show ethernet ring g8032 summary
Wed Mar 16 07:14:52.419 UTC
Chassis Node Id 0026.982b.c6e7
States
-----------------------------
Init
Idle
Protection
Manual Switch
Forced Switch

Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release

6.1.x
316
APS-Channel: Bundle-Ether100.1
Status: RPL, faulty, blocked
Remote R-APS NodeId: 0000.0000.0000, BPR: 0
APS-Channel: GigabitEthernet0/0/0/38.1
Status: NonRPL
Remote R-APS NodeId: 0000.0000.0000, BPR: 0
WTR interval: 5 minutes
Guard interval: 500 milliseconds
Hold-off interval: 0 seconds
Revertive mode
APS-Channel: GigabitEthernet0/0/0/33.1
Status: RPL, blocked
Remote R-APS NodeId: 0000.0000.0000, BPR: 0
APS-Channel: GigabitEthernet0/0/0/3.1
Status: NonRPL
Remote R-APS NodeId: 0000.0000.0000, BPR: 0
WTR interval: 5 minutes
Guard interval: 500 milliseconds
Hold-off interval: 0 seconds
Revertive mode
0
1
1
0
0
Inst NodeType NodeState
1 Owner Protection
1 Owner Idle
Multipoint Layer 2 Services Commands
Port0 Port1
R,F,B
R,B