Cisco Asr 9000 Series Aggregation Services Router Vpn And Ethernet Services Command Reference, Release - Cisco ASR 9000 Series Reference Manual

identifier
Examples
This example shows how to set the Ethernet segment identifier value of an interface in the EVPN interface
Ethernet segment configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# evpn
RP/0/RSP0/CPU0:router(config-evpn)# interface bundle-ether 1
RP/0/RSP0/CPU0:router(config-evpn-ac)# ethernet segment
RP/0/RSP0/CPU0:router(config-evpn-ac-es)# identifier system-priority 2 system-id 1.1.1
Related Commands
Command
ethernet-segment, on page 396
load-balancing-mode, on page 415
service-carving, on page 431
backbone-source-mac, on page 387

Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release

6.1.x
408
Description
Enters EVPN interface ethernet segment configuration mode.
Sets the load balancing mode of a physical port or bundle to
active-active.
Specifies the list of service identifiers as active and standby
services.
Configures the backbone source MAC address.
Provider Backbone Bridge Commands