Ipv6 Address (Lxvpn) - Cisco ASR 9000 Series Reference Manual

Generic Routing Encapsulation Commands

ipv6 address (LxVPN)

To set the IPv6 address of the tunnel interface, use the ipv6 address command in interface configuration
mode. To remove the IPv6 addresses, use the no form of this command.
ipv6 {address zone {prefix length| link-local} [route-tag value]| zone/length [route-tag value]}
no ipv6 {address zone {prefix length| link-local} [route-tag value]| zone/length [route-tag value]}
Syntax Description
zone
prefix length
link-local
route-tag
value
Command Default
None
Command Modes
Interface configuration
Command History
Release
Release 4.2.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
Task ID
network
interface
ipv6
Specifies the IPv6 address of the interface.
Specifies the length of the IPv6 address prefix, in bits. The range is from
1 to 128.
Specifies the link-local address.
Specifies the tag associated with the address.
Tag value. The range is from 1 to 4294967295.
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
Modification
This command was introduced.
Operations
read, write
read, write
read, write

ipv6 address (LxVPN)

6.1.x
37