Edge-Mode - Cisco ASR 9000 Series Reference Manual

Multiple Spanning Tree Protocol Commands

edge-mode

To enable MSTAG edge mode for Multiple Spanning Tree Instance (MSTI), use the edge-mode command
in MSTAG instance configuration submode. Use the no form of this command to disable the MSTAG edge
mode.
edge-mode
no edge-mode
Syntax Description
This command has no keywords or arguments.
Command Default
Disabled
Command Modes
MSTAG instance configuration mode
Command History
Release
Release 4.1.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
Task ID
ethernet-services
Examples
This example shows the output from the edge-mode command:
RP/0/RSP0/CPU0:router#configure
RP/0/RSP0/CPU0:router(config)#spanning-tree mstag A
RP/0/RSP0/CPU0:router(config-mstag)#interface GigabitEthernet 0/2/0/1.1
RP/0/RSP0/CPU0:router(config-mstag-if)#instance 100
RP/0/RSP0/CPU0:router(config-mstag-if-inst)#edge-mode
RP/0/RSP0/CPU0:router(config-mstag-if-inst)#
Related Commands
Command
spanning-tree mstag, on page 625
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
Modification
This command was introduced.
Operation
read, write
Description
Enters the MST Access Gateway configuration submode.
edge-mode
6.1.x
495