Ipv4 Source - Cisco ASR 9000 Series Reference Manual

ipv4 source

ipv4 source

To configure source IP address for the pseudowire class with encapsulation mpls, use the ipv4 source command
in the L2VPN pseudowire class encapsulation mpls configuration mode.
ipv4 source source-ip-address
Syntax Description
source-ip-address
Command Default
None
Command Modes
L2VPN pseudowire class encapsulation mpls configuration
Command History
Release
Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
Task ID
l2vpn
Examples
This example shows how to configure the source ip address:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)#l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)#pw-class kant1
RP/0/RSP0/CPU0:router(config-l2vpn-pwc)#encapsulation mpls
RP/0/RSP0/CPU0:router(config-l2vpn-pwc-mpls)#ipv4 source 112.22.1.4
Related Commands
Command
pw-class encapsulation mpls, on page 128
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
86
Point to Point Layer 2 Services Commands
Source IP address.
Modification
This command was introduced.
Operation
read, write
Description
Configures MPLS pseudowire encapsulation.