Pw-Grouping - Cisco ASR 9000 Series Reference Manual

Point to Point Layer 2 Services Commands

pw-grouping

To enable Pseudowire Grouping, use the pw-grouping command in L2vpn configuration submode. To return
to the default behavior, use the no form of this command.

pw-grouping

no pw-grouping
Syntax Description
pw-grouping
Command Default
PW-grouping is disabled by default.
Command Modes
L2VPN configuration submode
Command History
Release
Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
Task ID
l2vpn
Examples This example shows the sample output of pw-grouping configuration in L2VPN configuration submode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# pw-grouping
Related Commands
Command
l2vpn, on page 100
show l2vpn, on page 158
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
Enables Pseudowire Grouping.
Modification
This command was introduced.
Operation
read, write
Description
Enters L2VPN configuration mode.
Displays L2VPN information
pw-grouping
6.1.x
133