Parameters; Parameter List - Mitsubishi Electric MR-JE-_A Instruction Manual

5. PARAMETERS

5. PARAMETERS
CAUTION

5.1 Parameter list

Never make a drastic adjustment or change to the parameter values as doing so
will make the operation unstable.
Do not change the parameter settings as described below. Doing so may cause
an unexpected condition, such as failing to start up the servo amplifier.
Changing the values of the parameters for manufacturer setting
Setting a value out of the range
Changing the fixed values in the digits of a parameter
POINT
To enable a parameter whose symbol is preceded by *, turn off the power for 1 s
or more after setting and turn it on again. However, the time will be longer
depending on a setting value of [Pr. PF25 instantaneous power failure tough
drive - detection time] when "Instantaneous power failure tough drive selection"
is enabled in [Pr. PA20].
The symbols in the control mode column mean as follows.
P: Position control mode
S: Speed control mode
T: Torque control mode
5 - 1