Table of Contents
Advertisement
Telemetry Function ON/OFF
The telemetry data can be viewed at the HOME screen and telemetry ON/OFF screen.
The telemetry function can also be turned on and off at the telemetry ON/OFF screen.
The telemetry ON/OFF and communication status can be checked at the HOME screen.
The reception strength
The reception strength is shown.
- Telemetry function :ON
- Receiver ID setting complete.
- Data receiving sensitivity display.
-
shows that data cannot be received be-
cause it is outside the data receiving range or
because of the effects of an obstruction or the
receiver power is OFF after receiver ID check.
Refer to the map on page 116 for the telemetry ON/OFF (telemetry) screen display.
(HOME screen)
RPM Sensor info
Temperature Sensor info
Telemetry function ON/OFF
(Preparation)
- On the HOME screen, open the TELEMETRY ON/OFF
screen by pressing the (+) button.
1
Select the setting item "MODE" using the
(JOG) button up or down operation. Set the
function by pressing the (+) or (-) button.
"OFF" : Function OFF
"ON"
: Function ON
2
When completed, move the cursor to [RT] by the (JOG) but-
ton, and return to the HOME screen by pressing the (JOG)
button.
High
Low
No signal reception
Receiver -> Transmitter:
- Telemetry function :ON
- Receiver ID before setting or ID mis-
match.
- When the receiver ID is set, before
ID check in the receiver power OFF
state.
Receiver voltage info
Voltage Sensor info
Telemetry "TELEMETRY"
Telemetry function :OFF
(TELEMETRY ON/OFF screen)
Receiver voltage info
Temperature Sensor info
RPM Sensor info
Voltage Sensor info
Telemetry turned ON, LED of
the jog key will blink twice.
Function ON/OFF (MODE)
INH, ACT
Select button
- Select with the (+) or (-) but-
tons.
117
Advertisement
Table of Contents
