Sagem F@st 1201 Reference Manual page 97

Field
Physical LAN Port
Protocol
Differentiated Services
Code Point (DSCP)
Check
Source IP Address
Source Subnet Mask
UDP/TCP source Port
(port or port:port)
Destination IP Address Enter a "Destination" IP address.
SET-1 Destination Subnet
Mask
UDP/TCP Destination
Port
(port or port:port)
Source MAC Address
Source MAC Mask
Destination MAC
Address
Destination MAC Mask
SET-2 802.1p Priority
Sagem Communications document. Reproduction and disclosure prohibited
5 - Information / Configuration
Select Blank or the interface of your choice (ETH or
USB) from the scroll down list.
Select Blank or the protocol of your choice from the
scroll down list (TCP/UDP, TCP, UDP or ICMP).
Select the type of Differentiated Services Code
Point (DSCP) mark to be allocated
(6-bit coding) from the scroll down list.
Default to CS7
See the first table of this chapter.
Enter a "Source" IP address.
Enter a "Source" subnet mask.
Enter a "Source" port or range of ports.
Note: For one port, for example, enter 80. For a
range of ports, enter 80:90.
Enter a "Destination" subnet mask.
Enter a "Destination" port or range of ports.
Note: For one port, for example, enter 80. For a
range of ports, enter 80:90.
Enter a "Source" MAC address.
Enter a "Source" MAC mask.
Enter a "Destination" MAC address.
Enter a "Destination" MAC mask.
Select Blank or a priority value between 0 and 7
from the scroll down list.
Note: 802.1p Priority cannot be selected together
with IP traffic condition.
SAGEM F@st™ 1201/1241 V2 Reference Manual - 253151640-A
Action
: 000000 to 111000
Page 5-63