Sagem F@st 1201 Reference Manual page 75

Field
PPP IP extension
Use Static IP Address
5
IP Address:
Retry PPP password on
authentication error
Configure PPP MTU
Enable PPP Debug mode Check the box to use the PPP Debug mode.
Bridge PPPoE frames
between WAN and local
ports
Only Bridge PPPoE
Frames
Stop when the username
is empty
Note: The MTU specifies the maximum size of the data used (IP packets) expressed as a
number of bytes.
•
Click on the Next button to continue configuring the remote network (WAN) in
PPPoE/PPPoA mode.
Sagem Communications document. Reproduction and disclosure prohibited
Action
Check the box to allocate the public address
obtained from the DHCP server of your
Internet Service Provider (ISP) to your
computer. Your router will then act as a bridge
between the server and your computer.
Check the box to use the static IP address.
Enter the static IP address.
Enter an MTU (Maximum Transfer Unit) value.
This value (in bytes) is between 38 and 1492
(see Note).
In the event of connection failure, this option
will enable you to trace a possible problem in
the SYSLOG file.
Check the box to enable the router when
bridging the frames between WAN and local
Ethernet ports
Check the box to filter out all the non-PPPoE
packets when bridging the frames between
WAN and local ports.
Check the box to forbid the Internet
connection when you enter an empty
password
SAGEM F@st™ 1201/1241 V2 Reference Manual - 253151640-A
5 - Information / Configuration
Not checked
Not checked
Box checked
Default
_
_
0.0.0.0
Box
1492
Box
Checked
Checked
Page 5-41