Sagem F@st 1201 Reference Manual page 162

Annex A - Troubleshooting
State of connection
State
PASS
DOWN
FAIL
If a test displays a "FAIL" state, click on "Help" and then the button
"Rerun Diagnostic Tests" at the bottom of the "Help" page, to check that the test
has been conclusive. If the test still displays "FAIL", you must follow the
troubleshooting procedure displayed on this page.
If you experience difficulties connecting to the Internet, we recommend that you restart your
router (cf.A.6) or possibly re-establish the factory configuration (cf. § A.8).
SAGEM F@st™ 1201/1241 V2 Reference Manual - 253151640-A
Page A-6 Sagem Communications document. Reproduction and disclosure prohibited
Colour
Green Indicates that the test has completed successfully.
Orange Indicates that an interface (ETH or USB) has not been detected.
Red Indicates that the test has failed, or that it is impossible to start a
command.
Note: Depending on the nature of the test, it is possible that
operation of the router or access to the Internet may not be
prejudiced. For example if you do a "Ping" either to an ATM OAM
F5 segment or to a DNS primary address.
Meaning
IMPORTANT