Sagem F@st 1201 Reference Manual page 58

5 - Information / Configuration
Field
Inactivity Timeout
(minutes) [1-4320]:
PPP IP extension
Use Static IP Address
IP Address:
Retry PPP password on
authentication error
Configure PPP MTU
Enable PPP Debug mode Check the box to use the PPP Debug mode.
Stop when the username
is empty
Note: The MTU specifies the maximum size of the data used for packets expressed as a
number of bytes.
4
This field only appears when the "Dial on demand (with idle timeout timer)" field is activated (box checked).
5
This field only appears when the "Use Static IP Address" field is activated (box checked).
SAGEM F@st™ 1201/1241 V2 Reference Manual - 253151640-A
Page 5-24 Sagem Communications document. Reproduction and disclosure prohibited
Enter a value expressed in minutes between
4
1 and 4320 (i.e. 72 hours).
Check the box to allocate your computer the
public address obtained from the DHCP
server of your Internet Service Provider
(ISP). Therefore, your router will act as a
bridge between the server and your
computer.
Check the box to use the static IP address.
5
Enter the static IP address
When the box is not checked, the number of
attempts is limited to enter your password.
Check the box not to be limited by the
number of attempts.
Enter an MTU (Maximum Transfer Unit)
value between 38 and 1492 (see Note).
In the event of connection failure, this option
will enable you to trace a possible problem
in the SYSLOG file.
Check the box to forbid the Internet
connection when you enter an empty
password
Action Default
0
Box
Not checked
Box
Not checked
0.0.0.0
Box
Not checked
1492
Box
Not checked
Box
Not checked