Sagem F@st 1201 Reference Manual page 45

Proceed as follows:
Check the "Select a Service" box, then select the service of your choice from the scroll
down list, for example "SNMP".
The "External Port Start", "External Port End", "Internal Port Start", "Internal Port End"
and Protocol fields (transport protocol associated with this service) are automatically filled
in the table.
Note: You may complete the table by adding other ports associated with a protocol.
or
Check the "Custom Server" box, enter the name of the server you want to connect to, then:
•
Complete the ID Host of your computer's IP address (this is attributed by your router's
DHCP server).
•
Fill in the "External Port Start", "External Port End", "Internal Port Start",
"Internal Port End" and "Protocol" fields.
A few rules for entering values:
When you want to select a single port, the start port ("External Port Start" or "Internal
Port Start") and the end port ("External Port End" or "Internal Port End") must be
identical.
When you want to select a range of ports, the start port number must be lower than
the end port number.
You must always start entering with the "External Port Start" and "External Port End"
ports,
When you allocate a number to an "External Port Start", the same number is
automatically allocated
"External Port End",
Sagem Communications document. Reproduction and disclosure prohibited
to the "Internal Port
SAGEM F@st™ 1201/1241 V2 Reference Manual - 253151640-A
5 - Information / Configuration
Start" and identically for
Page 5-11