Config Firmware Image_Id; Show Boot_File - D-Link DGS-1210/ME Series Reference Manual

# Copyright(C) 2010 D-Link Corporation. All rights reserved.
#--------------------------------------------------------------------------------------------------------
# User Account
disable password encryption
# Basic
config syslogintimeout 5
enable web 80
enable clipaging
config command_prompt default
config serial_port baud_rate 9600
config serial_port auto_logout 10_minutes
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a ALL

config firmware image_id

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the firmware image of the Switch:
DGS-1210-28MP/ME:5# config firmware image_id 1 boot_up
Command: config firmware image_id 1 boot_up
Success.
DGS-1210-28MP/ME:5#

show boot_file

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
Used to configure the firmware image id.
config firmware image_id <value 1-2> [boot_up | delete]
The config firmware image_id command is used to configure the
firmware image id.
<value 1-2>- Specify the image id to be configured.
[boot_up | delete] – Specify to boot up or delete the specified image
id.
Only Administrator -level users can issue this command.
Used to display the configuration file and firmware image assigned
as boot up files.
show boot_file
The show boot_file command is used to display the configuration
file and firmware image assigned as boot up files.
None.
None.
126