Config Configuration Config_Id; Show Firmware Information - D-Link DGS-1210/ME Series Reference Manual

Example usage:
DGS-1210-28MP/ME:5# upload log_toTFTP 172.21.45.73 log1
Command: upload log_toTFTP 172.21.45.73 log1
Success.
DGS-1210-28MP/ME:5#

config configuration config_id

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
DGS-1210-28/ME:5# config configuration config_id 1 boot_up
Command: config configuration config_id 1 boot_up
Success.
DES-1210-52/ME:5#

show firmware information

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
DGS-1210-28MP/ME:5# show firmware information
Command: show firmware information
Current
Configured : image one
IMAGE ONE:
Version
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
Used to delete the specific firmware or configure the specific
firmware as boot up image.
config configuration config_id <value 1-2> [boot_up | delete]
The config configuration config_id command is used to delete the
specific firmware or configure the specific firmware as boot up
image.
<value 1-2> − Specifies the serial number of the indicated
configuration.
[boot_up | delete] − Specifies the config is boot_up config or delete
the specified configuration.
Only Administrator or operator-level users can issue this command.
Used to display the firmware section information.
show firmware information
The show firmware information command is used to display the
firmware section information.
None.
None.
: image one
: 7.01.B030
124