Create Ipv6Route; Delete Ipv6Route - D-Link DGS-1210/ME Series Reference Manual

To display the contents of the IP routing table:
DGS-1210-28MP/ME:5# show iproute
Command: show iproute
Routing Table
IP Address/Netmask Gateway
---------------------------- --------------- -------------
10.0.0.0/8
Total Entries :1
DGS-1210-28MP/ME:5#

create ipv6route

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To add a single static IPv6 entry in IPv6 format:
DGS-1210-28MP/ME:5# create ipv6route default FEC0::5
Command: create ipv6route default FEC0::5
Success.
DGS-1210-28MP/ME:5#

delete ipv6route

Purpose
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
Interface
0.0.0.0 System
Used to create an IPv6 static route in the Switch's IP routing table.
create ipv6route [<ipv6networkaddr> | default] <ipv6addr>
[metric <int 1-65535>] {[primary | backup]}
This create ipv6route command is used to create a primary and
backup IP route entry to the Switch's IP routing table.
<ipv6networkaddr> − To specify the destination network for the
route.
default – To create a default IPv6 route entry.
<ipaddr> – To specify the IPv6 address for the next hop route.

metric <int 1-65535> – To specify the hop cost, and the default
is 1. The value ranges between 1 and 65535.

primary – To specify the route as the primary route to the
destination.

backup – To specify the route as the backup route to the
destination. If the route is not specified as the primary route or
the backup route, then it will be auto-assigned by the system.
The first created is the primary, the second created is the
backup.
Only Administrator or operator-level users can issue this command.
Used to delete a static IPv6 route entry from the Switch's IP routing
Hops Protocol
------- --------------
1 Local
338