Config Stp Priority; Enable Stp; Disable Stp - D-Link DGS-1210/ME Series Reference Manual

config stp priority

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To set the priority value for instance_id 2 as 4096:
DGS-1210-28MP/ME:5# config stp priority 4096 instance_id 2
Command: config stp priority 4096 instance_id 2
Success.
DGS-1210-28MP/ME:5#

enable stp

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable STP, globally, on the Switch:
DGS-1210-28MP/ME:5# enable stp
Command: enable stp
Success.
DGS-1210-28MP/ME:5#

disable stp

Purpose
Syntax
Description
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
To update the STP instance configuration.
config stp priority <value 0-61440> instance_id <value 0-15>
The config stp priority command updates the STP instance
configuration settings on the Switch. The MSTP uses the priority in
selecting the root bridge, root port and DGSignated port. Assigning
higher priorities to STP regions instructs the Switch to give
precedence to the selected instance_id for forwarding packets. A
lower value indicates a higher priority.
priority <value 0-61440> - The priority for a specified instance_id for
forwarding packets. The value may be between 0 and 61440, and
must be divisible by 4096. A lower value indicates a higher priority.
instance_id <value 0-15> - The value of the previously configured
instance id for which the user wishes to set the priority value. An
instance_id of 0 denotes the default instance_id (CIST) internally set
on the Switch.
Only administrator-level users can issue this command.
To globally enable STP on the Switch.
enable stp
The enable stp command is used to set the Spanning Tree Protocol
to be globally enabled on the Switch.
None.
Only administrator-level users can issue this command.
To globally disable STP on the Switch.
disable stp
The disable stp command is used to set the Spanning Tree
175