To display the current state of the auto update feature:
config firmware
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To specify the system image:
show firmware information
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the active system image file:
DGS3100# show dhcp_auto
Dhcp auto update status: Disable
DGS3100#
To specify the system image that the device will load at reboot or to
specify a system image to delete.
config firmware [delete | boot_up] {unit <unit_id 1-6>} image_id
<image 1-2>
The config firmware command specifies the system image that the
device loads at startup, or the specific image that is to be deleted.
−
Deletes the specified firmware on the specified unit.
delete
−
Specifies the firmware image that will be used for the next boot-
boot_up
up.
−
Specifies the unit ID number. (Range:
unit
−
Specifies the system image ID number.
Image_id
It is only possible to delete a non-active image.
DGS3100# config firmware unit 1 image_id 1
Success
DGS3100#
To
display the active system image file loaded by the device
show firmware information
show firmware information
The
stored image files, and indicates those that are currently active.
None
None.
DGS3100# show firmware information
Unit
Image
Version
----
----------
----------
1
1
1.ep.58
1
*2
2.00.10
4
1
1.ep.58
4
*2
2.00.10
5
1
1.ep.58
5
*2
2.00.10
DGS3100#
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
command
Update Time
-------------------
28-Nov-2007 19:22:43
20-Nov-2007 15:21:24
28-Nov-2007 19:22:43
20-Nov-2007 15:21:24
28-Nov-2007 19:22:43
20-Nov-2007 15:21:24
1-6)
.
displays the currently
54