Config Radius Add - D-Link DGS-1210/ME Series Reference Manual

Metro ethernet switches
Hide thumbs Also See for DGS-1210/ME Series:
Table of Contents

Advertisement

DGS-1210-28MP/ME:5# config 802.1x reauth port_based ports 1-18
Command: config 802.1x reauth port_based ports 1-18
Success.
DGS-1210-28MP/ME:5#

config radius add

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the RADIUS server communication settings:
DGS-1210-28MP/ME:5# config radius add 1 3000::2 key 9999 acct_port 10
auth_port 12 retransmit 2 timeout 5
Command: config radius add 1 3000::2 key 9999 acct_port 10 auth_port 12
retransmit 2 timeout 5
Success.
DGS-1210-28MP/ME:5#
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
To configure the settings the Switch uses to communicate with a
RADIUS server.
config radius add <server_index 1-3> [<ipaddr> | <ipv6_addr>]
[key <passwd 32> | encryption_key <passwd 66>] {default |
auth_port <udp_port_number 1-65535> | acct_port
<udp_port_number 1-65535> | retransmit <int 1-255> | timeout
<int 1-255>}
The config radius add command configures the settings the Switch
uses to communicate with a RADIUS server.
<server_index 1-3> – The index of the RADIUS server.
[<ipaddr> | <ipv6_addr]> – The IPv4 or IPv6 address of the RADIUS
server.
[key | encryption_key] – Specifies that a password and encryption
key are to be used between the Switch and the RADIUS server.
<passwd 32> – The shared-secret key used by the RADIUS server
and the Switch. Up to 128 characters can be used.
default – Uses the default udp port number in both the auth_port and
acct_port settings.
auth_port <udp_port_number 1-65535> – The UDP port number for
authentication requests. The default is 1812.
acct_port <udp_port_number 1-65535> – The UDP port number for
accounting requests. The default is 1813.
retransmit <int 1-255> – The number of times the device resends an
authentication request when the server does not respond. The value
is between 1 and 255.
timeout <int 1-255> – Specifies the connection timeout. The value
may be between 1 and 255 seconds.
Only Administrator or operator-level users can issue this command.
374

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents