Modification - Sony MVS-8000X User Manual

4
Press the [INS] button.
When the edit point is on a keyframe, to insert the new
keyframe before the existing keyframe, hold down the
[SHIFT] button and press the [INS] button.
This inserts the current image as the new keyframe.
Inserting a keyframe may change the total duration of
the effect.
For details, see "Time Settings" (page 382).

Modification

Modifying keyframes
Use the following procedure in the keyframe control
block.
1
Press the [EDIT ENBL] button, turning it on.
2
Stop the effect at the desired edit point.
When the edit point is on a keyframe, this is what you
modify. If the edit point is between two keyframes, the
previous keyframe is what you modify.
Notes
In constant duration mode (see page 381) modification
is only possible when the edit point is on a keyframe.
3
Using image transformations or adding special effects,
modify the keyframe.
4
Press the [MOD] button.
Modifying more than one keyframe
simultaneously
You can modify a number of keyframes simultaneously.
There are three different cases for this operation.
• Modifying from the edit point to a particular keyframe
• Modifying all keyframes in the effect
• Modifying the keyframes in a specified range
The different procedures for these cases are now
described.
To modify from the edit point to a particular
keyframe
1
Press the [EDIT ENBL] button, turning it on.
2
Stop the effect at the first keyframe of the range to be
modified.
3
Carry out the necessary modifications.
4
Press the [FROM TO] button, turning it on.
The display in the numeric keypad control block
shows the current keyframe number, followed by
"TO."
5
Enter the number of the last keyframe to be modified
from the numeric keypad control block and press the
[ENTER] button to confirm.
6
Press the [MOD] button. Alternatively, hold down the
[SHIFT] button and press the [MOD] button.
For the difference in the result, see "Differences in the
changes when a number of keyframes are modified"
(page 393).
To modify the keyframes in a specified range
1
Press the [EDIT ENBL] button, turning it on.
2
Stop the effect at any keyframe within the range to be
modified.
3
Carry out the necessary modifications.
4
Press the [FROM TO] button, turning it on.
The display in the numeric keypad control block
shows the current keyframe number, followed by
"TO."
5
Using the numeric keypad in the numeric keypad
control block, carry out the following operations.
• To set the first keyframe in the range to be modified,
press the [CLR] button, then enter the keyframe
number, and press the [ENTER] button to confirm.
• To set the last keyframe in the range to be modified,
enter the keyframe number from the numeric
keypad, and press the [ENTER] button to confirm.
6
Press the [MOD] button. Alternatively, hold down the
[SHIFT] button and press the [MOD] button.
For the difference in the result, see "Differences in the
changes when a number of keyframes are modified"
(page 393).
Differences in the changes when a number
of keyframes are modified
When you select a number of keyframes to modify, and
press the [MOD] button alone or in combination with the
[SHIFT] button, the result of the operation differs as
shown below.
Modifying the keyframes by pressing the [MOD]
button alone
The modified parameter values are taken as absolute
values, and applied to all of the selected keyframes.
Creating and Editing Keyframes
393