Specifying The Region And Edit Points; Selecting The Region In Which Editing Applies; Setting The Edit Points - Sony MVS-8000X User Manual

Specifying the Region
and Edit Points
Selecting the Region in Which
Editing Applies
Selecting by control panel
Select the region in which the editing is applied by the
effect consisting of keyframes, using the region selection
buttons in the numeric keypad control block.
See step 2 of "Recalling a register from the numeric
keypad control block" (page 389).
Selecting by menus
This is convenient for selecting some of the regions
assigned to the numeric keypad control block or changing
the reference region.
Notes
The function of region selection buttons in the numeric
keypad control block is linked to the menu. If you carry out
region selection by pressing a region selection button, then
all the regions assigned to that button are selected.
1
In the Key Frame menu, press HF7 'Region Select.'
The Key Frame >Region Select menu appears.
On the left of the status area, region selection buttons
appear.
Depending on the region selection state, the following
indications appear.
Green text: the assigned regions include the reference
region.
Orange text: one of the assigned regions is selected.
White text: no assigned region is selected.
When any one or more of the regions assigned to the
region selection buttons is not selected, a red bar
appears within the button indication. The [STORE]
and [RCALL] buttons in the numeric keypad control
block flash amber.
2
Press a button indication on the left of the status area,
to select the button you want to assign.
The regions currently assigned to the button you
pressed appear on the right side of the status area.
3
In the <Region Select> group, press the button for the
region you want to select, turning it on.
4
In the <Ref Region Select> group, press the button
indication you want to make the reference region.
The button you pressed lights green.

Setting the Edit Points

EDIT ENBL button
CONST DUR button
SHIFT button
Editing buttons
Keyframe control block
To set the edit points, use any of the following operations
in the keyframe control block.
• To move the edit point to the keyframe immediately after
the current time (the position at which the effect is
currently stopped), press the [NEXT KF] button.

Specifying the Region and Edit Points

Edit point specification buttons
391