Deleting An Event - Sony MVS-8000X User Manual

• When auto insert mode is on, it is merged with the macro
being edited. However, the macro assigned to the button
is not executed.
• When auto insert mode is off, it is copied to the paste
buffer. Pressing the [PASTE] button in the keyframe
control block merges it with the macro being edited.
Specifying an edit point
To specify an edit point with the numeric keypad control
block and keyframe control block, use the following
procedure.
1
Recall the register of the macro (1 to 250) you want to
edit (see page 431).
2
In the numeric keypad control block, hold down the
[MCRO] button, and press the [STORE] button.
This assigns the numeric keypad control block and
keyframe control block to macro editing, and the
[MCRO] button in the numeric keypad control block
and the [EDIT ENBL] button in the keyframe control
block light red. The [STORE] button in the numeric
keypad control block flashes red.
3
Using any of the following methods, specify the edit
point.
• To move the edit point to the event immediately
following the current macro event, press the [NEXT
KF] button in the keyframe control block.
• To move the edit point to the event immediately
preceding the current macro event, press the [PREV
KF] button in the keyframe control block.
• To move to an edit point by specifying an event
number (the number showing the position of the
event in the macro execution sequence), press the
[GO TO KF] button in the keyframe control block,
then in the numeric keypad control block, enter the
target number and confirm with the [ENTER]
button.
Inserting an event
1
Specify the edit point. (See page 433.)
2
If required, press the [AUTO INS] button assigned to
a utility/shotbox control block or user preference
button, to toggle the auto insert mode on or off.
3
Create the event.
• When auto insert mode (see page 432) is on, the
event is automatically added to the macro.
• When auto insert mode is off, proceed to step 4.
4
When auto insert mode is off, press the [INS] button in
the keyframe control block.
5
Repeat steps 2 and 3 to insert the required events in the
macro.
Modifying a single event
1
Specify the edit point. (See page 433.)
2
When the [AUTO INS] button assigned to a utility/
shotbox control block button or user preference button
is lit, press this to turn the auto insert mode off.
3
Create the event.
4
Press the [MOD] button in the keyframe control block.
Modifying a particular range of events
1
Carry out steps 1 to 3 of the procedure in "Modifying
a single event" (the previous item).
2
Press the [FROM TO] button in the keyframe control
block, turning it on.
The numeric display in the numeric keypad control
block shows the current event number and the
indication "TO."
3
To set the start of the range to other than the current
event number, press the [CLR/AUTO TRANS] button
in the numeric keypad control block, then enter the
desired event number with the numeric keypad and
press the [ENTER] button. (This operation is not
required when using the current event number.)
4
Enter the event number for the end of the range and
press the [ENTER] button.
5
Press the [MOD] button in the keyframe control block.

Deleting an event

1
Specify the edit point. (See page 433.)
2
To delete multiple events simultaneously, press the
[FROM TO] button in the keyframe control block,
then enter the event numbers from the numeric keypad
control block to specify a range to be deleted. (This
operation is not required to delete the event at the edit
point only.)
3
Press the [DEL] button.
Macro Operations in the Numeric Keypad Control Block and the Keyframe Control Block
433