Setting The Screen Aspect Ratio (Format Menu) - Sony MVS-8000X User Manual

Current settings of format converter
2
Click [Format Converter].
The Format Converter menu appears.
3
To select the conversion format for SWR1 format
converter inputs 1 to 4, press [Input 1-4 Format] in the
<SWR1 FC Input> group.
A pop-up window appears.
4
Press the button for the desired signal format.
5
For "Input 5-8 Format" in MVS-7000X and "Input 9-
12 Format" and "Input 13-16 Format" in the MVS-
8000X, set the desired signal format in the same way
as in steps 3 and 4.
6
To set the output format for format converters 1 and 2,
in the <SWR1 FC Output> group press [Output 1-2
Format], then press the button for the desired format.
7
For "Output 3-4 Format," set the desired signal format
in the same way as in step 6.
8
With reference to steps 3 to 7, make the settings for
SWR2.
To delay unconverted input signals (frame delay
function)
When the signal format is 1080i/59.94 or 1080i/50, you
can press [Frame Delay] in the pop-up window shown in
step 3 and step 5 to delay input signals.
For the format of the format converter input signal, the
same format as the signal format is shown.
Notes
You can set the delay amount up to eight frames in units of
frames.
For details, see "Selecting the Input to Which the Frame
Delay Function Applies" (page 529).
Setting the Screen Aspect
Ratio (Format Menu)
Switch the screen aspect ratio to 16:9 or 4:3.
To set the screen aspect ratio, use the System >Format
menu.
Setting the screen aspect ratio
1
In the System >Format menu, press [Aspect].
The Aspect menu appears.
2
In the <Screen Aspect> group, select one of the
following.
• 16:9
• 4:3
• Independ: Set the screen aspect ratio separately for
M/E, P/P, and USER on the switcher, and for each
channel independently on the DME.
3
If you selected [Independ] in step 2, select from the
following.
Switcher Aspect: Make the setting for the switcher.
DME Aspect: Make the setting for the DME.
A menu appears according to the selection.
4
Carry out either of the following, depending on the
selection you made in step 3.
When you selected [Switcher Aspect]: In each of the
<M/E-1>, <M/E-2>, <M/E-3>, <M/E-4>, <P/P>,
and <USER> groups, select either [16:9] or [4:3].
When you selected [DME Aspect]: For each of the
<CH1> to <CH4> groups, select either [16:9] or
[4:3].
5
To confirm the above setting, press [Aspect Execute].
To cancel the setting and return to the original state,
press [Clear] without pressing [Aspect Execute].
When you press [Aspect Execute], a confirmation
message appears.
6
Press [Yes].

Setting the Screen Aspect Ratio (Format Menu)

473