Configuring Mib-View-Based Access Control In Snmpv2C; Establishing The Configuration Task - Huawei Quidway S9300 Configuration Manual - Network Management
Terabit routing switch
Hide thumbs
Also See for Quidway S9300:
- Configuration manual (603 pages) ,
- Configuration manual - multicast (262 pages) ,
- Hardware description (224 pages)
Table of Contents
Advertisement
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
1.8 Configuring MIB-View-based Access Control in
SNMPv2c
In SNMPv2c, you can control the NM Station to access the specified device by the MIB view.
1.8.1 Establishing the Configuration Task
Before configuring MIB-view-based access control in SNMPv2c, familiarize yourself with the
applicable environment, complete the pre-configuration tasks, and obtain the required data. This
can help you complete the configuration task quickly and accurately.
1.8.2 Configuring the SNMP Version
By default, the NM Station accesses the device through SNMPv3. To enable the NM Station to
access the device through SNMPv2c, you need to configure SNMPv2c.
1.8.3 Creating a MIB View
This part describes how to create a MIB view, and add the MIB of the specified feature into the
MIB view or remove the MIB of the specified feature from the MIB view.
1.8.4 Configuring MIB-View-based Access Control
This part describes how the NM Station manages the specified feature of the device in the MIB
view.
1.8.5 Checking the Configuration
After MIB-view-based access control in SNMPv2c is configured, you can view configurations
of SNMP.
1.8.1 Establishing the Configuration Task
Before configuring MIB-view-based access control in SNMPv2c, familiarize yourself with the
applicable environment, complete the pre-configuration tasks, and obtain the required data. This
can help you complete the configuration task quickly and accurately.
Applicable Environment
To set different authorities for NM Stations to access the switch, configure different MIB views
on the switch.
Pre-configuration Tasks
Before configuring MIB-view-based access control, complete the following tasks:
l
l
Data Preparation
To configure MIB-view-based access control, you need the following data.
No.
1
Issue 03 (2010-09-20)
Assigning an IP address to the switch
Configuring the routing protocol to make the switch and the NM Station accessible
Data
SNMP community name
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 SNMP Configuration
1-21
Advertisement
Table of Contents
