Optional) Enabling The Switch To Send Specified Alarms To The Nm Station - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Pre-configuration Tasks
Before configuring the Trap function, complete the following tasks:
l
l
Data Preparation
To configure the Trap function, you need the following data.
No.
1
2
3
4
5
6
1.17.2 (Optional) Enabling the switch to Send Specified Alarms to
the NM Station
Context
Do as follows on the switch enabled with the SNMP agent:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
snmp-agent trap enable
The switch is enabled to send alarms.
----End
Issue 03 (2010-09-20)
Assigning an IP address to the switch
Configuring the routing protocol to make the switch and the NMS accessible
Data
(Optional) Name of the feature that generates alarms
(Optional) Name of the alarm that is generated by the feature
Destination host address of Trap messages
(Optional) Source address of Trap messages
(Optional) Queue length of Trap messages
(Optional) Saving time of Trap messages
NOTE
When all trap functions are enabled through the snmp-agent trap enable command or at least three trap
functions are enabled through the snmp-agent trap enable feature-name command:
l you can run the snmp-agent trap disable command to disable all the enabled trap functions.
l you can run any one of the undo snmp-agent trap enable and undo snmp-agent trap disable
commands to restore all trap functions to their default status.
l To disable a specified trap function, you can run the undo snmp-agent trap enable feature-name
command.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 SNMP Configuration
1-57