1 SNMP Configuration
No.
2
1.8.2 Configuring the SNMP Version
By default, the NM Station accesses the device through SNMPv3. To enable the NM Station to
access the device through SNMPv2c, you need to configure SNMPv2c.
Context
Do as follows on the switch enabled with the SNMP agent.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
snmp-agent sys-info version v2c
The SNMP version is configured.
By default, SNMPv3 is configured.
----End
1.8.3 Creating a MIB View
This part describes how to create a MIB view, and add the MIB of the specified feature into the
MIB view or remove the MIB of the specified feature from the MIB view.
Context
Do as follows on the switch enabled with the SNMP agent.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
snmp-agent mib-view { excluded | included } view-name oid-tree
A MIB view is created.
----End
1-22
Data
Information about MIB objects
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Issue 03 (2010-09-20)