Creating A Mib View; Configuring Mib-View-Based Access Control; Checking The Configuration - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
By default, SNMPv3 is configured.
----End

1.7.3 Creating a MIB View

This part describes how to create a MIB view, and add the MIB of the specified feature into the
MIB view or remove the MIB of the specified feature from the MIB view.
Context
Do as follows on the switch enabled with the SNMP agent.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
snmp-agent mib-view { excluded | included } view-name oid-tree
A MIB view is created.
----End

1.7.4 Configuring MIB-View-based Access Control

This part describes how the NM Station manages the specified feature of the switch in the MIB
view.
Context
Do as follows on the switch enabled with the SNMP agent.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
snmp-agent community { read | write } { community-name1 | cipher community-name2 }
[ mib-view view-name | acl acl-number ] *
MIB-view-based access control is configured.
----End

1.7.5 Checking the Configuration

After MIB-view-based access control in SNMPv1 is configured, you can view configurations
of SNMP.
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 SNMP Configuration
1-19