1 SNMP Configuration
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
snmp-agent sys-info version v2c
The SNMP version is configured.
By default, only SNMPv3 is configured.
----End
1.4.4 Setting the SNMP Community Name
This part describes how to implement access right control by setting the SNMP community
name.
Context
Do as follows on the switch enabled with the SNMP agent.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
snmp-agent community { read | write } community-name
The community name of the agent is configured.
----End
1.4.5 Checking the Configuration
After SNMPv2c is configured, you can check the SNMP configurations, including the
community name and version information.
Prerequisite
The configurations of the Basic Functions of SNMPv2c are complete.
Procedure
l
l
----End
1-10
Run the display snmp-agent community command to view the community name of the
agent.
Run the display snmp-agent sys-info version command to view the SNMP version
information.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Issue 03 (2010-09-20)