Optional) Enabling The Switch To Send An Alarm Message Of A Specified Feature To The Nm Station; Configuring The Destination Host Of Informing Messages - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
When all trap functions are enabled through the snmp-agent trap enable command or at least
three trap functions are enabled through the snmp-agent trap enable feature-name command:
l you can run the snmp-agent trap disable command to disable all the enabled trap functions.
l you can run any one of the undo snmp-agent trap enable and undo snmp-agent trap
l To disable a specified trap function, you can run the undo snmp-agent trap enable feature-
----End
1.18.3 (Optional) Enabling the switch to Send an Alarm Message of
a Specified Feature to the NM Station
Context
Do as follows on the switch that requires an alarm to be enabled separately:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
snmp-agent trap enable feature-name feature-name trap-name trap-name
The switch is enabled to send an alarm message of a specified feature to the NM station.
To disable a specified trap function, you can run the undo snmp-agent trap enable feature-
name command.
----End

1.18.4 Configuring the Destination Host of Informing Messages

This part describes how to configure the destination address (IP address of the NM Station) for
trap messages.
Context
Do as follows on the switch enabled with the SNMP agent.
Procedure
Step 1 Run:
system-view
Issue 03 (2010-09-20)
NOTE
disable commands to restore all trap functions to their default status.
name command.
NOTE
When configuring the destination host, you must first ensure that the switch and the destination host are
reachable.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 SNMP Configuration
1-63