Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
snmp-agent group v3 group-name [ authentication | privacy ] [ read-view read-view
| write-view write-view | notify-view notify-view ]
Read/write authority of the user group is configured.
----End
1.13.5 Configuring User Information
NM Station user information configured on the NM Station and the device must be identical.
Otherwise, the NM Station cannot access the device.
Context
Do as follows on the switch enabled with the SNMP agent.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
snmp-agent usm-user v3 user-name group-name
Users are added into the SNMPv3 user group.
----End
1.13.6 Checking the Configuration
After MIB-view-based access control in SNMPv3 is configured, you can view configurations
of the MIB and users.
Prerequisite
The configurations of the MIB-View-based Access Control in SNMPv3 are complete.
Procedure
l
l
l
Issue 03 (2010-09-20)
Run the display snmp-agent group [ group-name ] command to view information about
the SNMP group.
Run the display snmp-agent mib-view command to view the information on the MIB view
Run the display snmp-agent usm-user [ engineid engineid | group group-name |
username user-name ] * command to view information about users in the SNMP group.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 SNMP Configuration
*
[ acl acl-number ]
1-43