Configuring An Ip-Trunk Interface; Establishing The Configuration Task; Creating An Ip-Trunk And Adding Member Interfaces To The Ip-Trunk - Huawei Quidway S9300 Configuration Manual - Wan Access

Quidway S9300 Terabit Routing Switch
Configuration Guide - WAN Access
Procedure
l
----End

3.4 Configuring an IP-Trunk Interface

This section describes how to configure an IP-Trunk interface. Detailed operations include
creating an IP-Trunk interface and adding interfaces to the IP-Trunk interface, and configuring
an IP address for the IP-Trunk interface, the lower threshold of Up links.

3.4.1 Establishing the Configuration Task

Before configuring an IP-Trunk interface, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the required data. This can help you complete
the configuration task quickly and accurately.
Applicable Environment
To improve the communication ability of links, sometimes, multiple POS ports are bound to an
IP-Trunk interface. The bandwidth of an IP-Trunk interface is the sum of bandwidth of all the
member interfaces.
In addition, IP-Trunk interfaces can improve link reliability. If a member port is Down, traffic
is switched to other available ports.
Pre-configuration Tasks
None
Data Preparation
To create an IP-Trunk interface, you need the following data.
No.
1
2
3
3.4.2 Creating an IP-Trunk and Adding Member Interfaces to the
IP-Trunk
You can create an IP-Trunk interface, add interfaces to the IP-Trunk interface, and configure
the member interfaces.
Issue 02 (2011-07-15)
Run the display interface [ interface-type [ interface-number ] ] command to check the
status, link layer protocol and configuration of the interface.
Data
IP-Trunk ID
IP address of the IP-Trunk interface
Lower threshold of Up links
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 HDLC and IP-Trunk Configuration
43