Features Of The Cisco Rfgw-10 Supervisor Engine 7-E - Cisco RFGW-10 Hardware Installation Manual

Cisco RFGW-10 Components
Figure 1-11
1
W S- X4
5- SU
P7 -E
ST AT
US
1
2
3

Features of the Cisco RFGW-10 Supervisor Engine 7-E

Table 1-8 Cisco RFGW-10 Supervisor Engine 7-E Features
Feature
Bandwidth per slot
Memory
Front panel features
STATUS LED
RESET switch
ACTIVE SUP LED
UTILIZATION LEDs
USB connectors
SECURE DIGITAL slot
Cisco RF Gateway 10 Hardware Installation Guide
1-18
Cisco RFGW Supervisor Engine 7-E
RE SE
T
AC TIV
E
SU P
U TI LI
ZA TI
O N
US B
2
S E C
3
4
5
STATUS LED
RESET switch (recessed)
ACTIVE SUP (active su-
pervisor engine) LED
Description
48-Gbps
2-GB (upgrade to 4-GB)
The status LED indicates the current health of the supervisor engine and the current
software state. See
The RESET switch is used to reset and restart the switch.
Note
Use a paper clip or other small, pointed object to press the RESET switch.
The active supervisor engine LED indicates whether the supervisor engine is active or
in standby mode in redundant supervisor engine configurations. See
Eight LEDs indicate (as an approximate percentage) the current traffic load over the
backplane. SeeTable
Two USB 2.0 ports are provided. Port 1 operates in device mode (upstream) and port 2
in host mode (downstream). Port 1 has a standard Type B USB connector and can be
used as a USB console.Port 2 has a USB type A connector and a standard USB 2.0 device
like a flash memory device can plug into this connector.
A standard Secure Data (SD) memory card interface is provided on the front panel
U R E
CO NS
D IG IT O LE 10 /1 00 /1
A L
00 0
M G T
1- 2 AC
TI VE 1G /1 0G
UP LI NK
S (S FP
'S FP +)
3- 4 AC
TI VE
LIN K
1G
10 G
7
6
9
8
4
UTILIZATION LEDs
5
USB ports
6
SECURE DIGITAL slot
Table 1-9.
1-9.
Chapter 1
7
CONSOLE port (RJ-45
connector)
8
10/100/1000 MGT port (RJ-45
connector)
9
1G/10G UPLINKS (SFP/SFP+)
ports
Table 1-9.
OL-16264-04
Overview