Table of Contents
Advertisement
Chapter 5
Installing and Removing FRUs
Figure 5-18
Caution
When pulling the tab to remove the SFP module, be sure to pull in a straight outward motion. Do not
twist or forcibly pull the tab because you may disconnect it from the SFP module.
To remove the SFP module from the switching module port, pull the tab gently until the SFP module
disengages from the port, and then pull the SFP module out (see
Figure 5-19
Actuator/Button SFP Modules
The actuator/button SFP module (see
module from a switching module port.
Figure 5-20
To insert the actuator/button SFP module into a switching module port, line up the SFP module with the
port and slide it in until the actuator/button clicks into place (see
actuator/button as you insert the SFP module because you might inadvertently disengage the SFP module
from the port.
OL-16264-04
Inserting a Mylar Tab SFP Module
W S - 4
4 4 8 - G
B - L X
1
2
S T A T
U S
Removing a Mylar Tab SFP Module
W S - 4
4 4 8 - G
B - L X
1
3
5
2
4
S T A T
U S
6
2
4
6
Figure
Actuator/Button SFP Module
Installation and Removal of the SFP Modules
3
5
7
4
6
8
2
4
6
8
7
8
8
5-20) has a button that you must push to remove the SFP
Cisco RF Gateway 10 Hardware Installation Guide
Figure
5-19).
Figure
5-21). Be sure not to press the
5-29
Advertisement
Table of Contents
