Cisco RFGW-10 Hardware Installation Manual page 131

Chapter 5 Installing and Removing FRUs
Figure 5-14
Step 6
Align the edges of the DS-48 line card carrier with the slot guides on the top and bottom of the Cisco
RFGW-10 UEQAM chassis, as shown in
Note
The DS-48 line cards slide into the chassis guides on the sheet metal carrier edge.
Step 7
Pivot the two module ejector levers out and away from the faceplate.
Step 8
Carefully slide the DS-48 line card into the appropriate slot until the notches on both the ejector levers
engage the chassis top and bottom.
Step 9
Using your thumb and forefinger of each hand to simultaneously pivot in both the ejector levers to fully
seat the DS-48 line card in the backplane connectors.
Caution
Always use the ejector levers when installing or removing a DS-48 line card. A DS-48 line card that is
partially seated in the backplane will not function correctly.
Note
The DS-48 line card sheet metal carrier faceplate has holes on the top and bottom for aligning to the
chassis pin features. This feature aids in positioning each line card faceplate within the chassis. See
Figure
OL-16264-04
Installing the DS-48 Line Card in the Chassis
ESD-preventive
strap
5-15.
Installation and Removal of the Line Cards
Figure 5-14.
Cisco RF Gateway 10 Hardware Installation Guide
5-25