Table of Contents
Advertisement
Chapter 3
Cisco RFGW-10 UEQAM Installation
To install the rack-mount brackets for a mid-mounted configuration on a Cisco RFGW-10 UEQAM,
complete the following steps:
Step 1
Locate the threaded holes on the middle sides of the chassis that align with the holes in the rack-mount
bracket. Ensure that you hold the front rack-mount bracket with the ear and holes facing outward and
towards the rear of the chassis (see
Step 2
Install all the six M5 undercut flat-head screws (provided in the accessory kit) to secure each of the
rack-mounting bracket to the chassis. There will be three screws installed on each end of the
rack-mounting bracket.
Step 3
Repeat Step 1 through Step 2 on the other side of the chassis.
Step 4
Install the chassis in the rack. To install the Cisco RFGW-10 UEQAM in a rack, go to
Cisco RFGW-10 UEQAM in a Rack" section on page
Figure 3-7
1 Cisco RFGW-10 Chassis
2 Rack-mount screws
OL-16264-04
Figure
3-7).
Attaching the Rack-Mount Brackets for Mid-Mount Configuration to the Cisco RFGW-10 Chassis
Attaching the Chassis Rack-Mount Brackets
3-12.
3
3 Rack-mount bracket
Cisco RF Gateway 10 Hardware Installation Guide
"Installing the
1
2
3-11
Advertisement
Table of Contents
