Part Numbers - Cisco RFGW-10 Hardware Installation Manual

Chapter 6 Cabling the Cisco RFGW-10 UEQAM
Figure 6-5
connectors
Caution
The Cisco RFGW-10 UEQAM must be used with the UCH for all cable connections to the RF Switch
Card. Failure to use the UCH may cause permanent damage to the line card connectors, resulting in low
or no RF output in the downstream or low or no RF input in the upstream.
Note
The cable used with the dense connector UCH must be 75-ohm precision miniature video cable and
Cisco specified MCX connectors.

Part Numbers

Table 6-1
connectors, tubing, and tools.
Table 6-1 Part Numbers
Description
Cisco RFGW-10 RF switch line card
Cisco Cable kit (3m MCX to F cables)
10 Quad-shielded RF cables, preconnected UCH2 header,
RFGW/3G60 to HFC, 3m.
12 Cable kits required for Cisco RFGW-10 Chassis.
OL-16264-04
5-Bundle Quad-Shielded Cable with MCX Connectors
MCX
F connectors
lists the part numbers for the Cisco RFGW-10 UEQAM RF Switch cards, cable kits, cables,
Part Numbers
RFGW-10-RFSW1
CAB-RFGW3G60QTIMF, Cisco Systems, Inc.
Cisco RF Gateway 10 Hardware Installation Guide
6-5