Two-Post Rack Installation Mid-Mounted - Cisco RFGW-10 Hardware Installation Manual

Installing the Cisco RFGW-10 UEQAM in a Rack

Two-Post Rack Installation Mid-Mounted

The Cisco RFGW-10 chassis can be installed in a two-post 19-inch rack either as a front mount or a
mid-mount (see
Caution
If you are using a two-post rack, secure the rack to the floor surface to prevent tipping and avoid bodily
injury and component damage.
Step 1
On the chassis, ensure that all the screw fasteners on the installed components are securely tightened.
Step 2
Ensure that your path to the rack is unobstructed. If the rack is on wheels, ensure that the brakes are
engaged or that the rack is otherwise stabilized. See the section on the types of racks you can use to
install the chassis.
Step 3
(Optional) Install the chassis installation bracket into the rack to help support the chassis during
installation (see
it to the rack.
Figure 3-11
Step 4
With two people, lift the chassis (partially unloaded) into position between the rack posts and rest it on
the chassis installation bracket.
Step 5
Position the chassis until the rack-mounting flanges flush against the mounting rails on the rack.
Step 6
Hold the chassis in position against the mounting rails and follow these steps:
a.
Cisco RF Gateway 10 Hardware Installation Guide
3-16
Figure 3-12).
Figure 3-11). If you use the bracket, this will help support the chassis while you secure
Chassis Installation Bracket
Chassis
installation
bracket
Insert a bottom screw into the rack-mount ear on each side and use a hand-held screwdriver to
tighten the screw to the rack rail.
Chapter 3 Cisco RFGW-10 UEQAM Installation
OL-16264-04