Table of Contents
Advertisement
Standard Warning Statements
This equipment must be grounded. Never defeat the ground conductor or operate the equipment
Warning
in the absence of a suitably installed ground conductor. Contact the appropriate electrical
inspection authority or an electrician if you are uncertain that suitable grounding is available.
Statement 1024
Warning
Hazardous voltage or energy is present on the backplane when the system is operating. Use
caution when servicing. Statement 1034
Class 1 laser product. Statement 1008
Warning
Class 1 LED product. Statement 1027
Warning
Laser radiation is present when the system is open. Statement 1009
Warning
Do not stare into the laser beam. Statement 1010
Warning
Warning
Class I(CDRH) and Class 1M (IEC) laser products. Statement 1055
Warning
Invisible laser radiation may be emitted from the end of the unterminated fiber cable or
connector. Do not view directly with optical instruments. Viewing the laser output with certain
optical instruments (for example, eye loupes, magnifiers, and microscopes) within a distance of
100 mm may pose an eye hazard. Statement 1056
To prevent personal injury or damage to the chassis, never attempt to lift or tilt the chassis using
Warning
the handles on modules (such as power supplies, fans, or cards); these types of handles are not
designed to support the weight of the unit. Statement 1032
To prevent the system from overheating, do not operate it in an area that exceeds the maximum
Warning
recommended ambient temperature of: 40 degrees C. Statement 1047
This equipment must be externally grounded using a customer-supplied ground wire before
Warning
power is applied. Contact the appropriate electrical inspection authority or an electrician if you
are uncertain that suitable grounding is available. Statement 366
Cisco RF Gateway 10 Hardware Installation Guide
2-6
Chapter 2
Preparing Your Site for Installation
OL-16264-04
Advertisement
Table of Contents
