Installing The Cisco Rfgw-10 Ueqam In A Rack - Cisco RFGW-10 Hardware Installation Manual

Installing the Cisco RFGW-10 UEQAM in a Rack

Installing the Cisco RFGW-10 UEQAM in a Rack
After installing the rack-mount brackets, the installation handles on the chassis, and the installation
brackets in the rack, mount the chassis by securing the rack-mount brackets to the two posts or mounting
strips in the rack. Because the rack-mount brackets supports the weight of the entire chassis, be sure to
use at least four rack-mount screws on each side to fasten the two rack-mount brackets to the rack posts.
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
Warning
precautions to ensure that the system remains stable. The following guidelines are provided to
ensure your safety:
- This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
- When mounting this unit in a partially filled rack, load the rack from the bottom to the top with
the heaviest component at the bottom of the rack.
- If the rack is provided with stabilizing devices, install the stabilizers before mounting or
servicing the unit in the rack. Statement 1006
Caution
Before you proceed, read the instructions in
To install the chassis in the rack, complete the following steps:
Step 1
On the chassis, ensure that all the screw fasteners on the installed components are securely tightened.
Step 2
Ensure that your path to the rack is unobstructed. If the rack is on wheels, ensure that the brakes are
engaged or that the rack is otherwise stabilized.
Step 3
(Optional) Install the chassis installation brackets into the rack to help support the chassis during
installation (see
it to the rack.
Step 4
With two people, lift the chassis (partially unloaded) into position between the rack posts and rest it on
the chassis installation bracket (see
Cisco RF Gateway 10 Hardware Installation Guide
3-12
Figure 3-4). If you use the brackets, this will help support the chassis while you secure
Figure
Chapter 3
"Chassis-Lifting Guidelines" section on page
3-8).
Cisco RFGW-10 UEQAM Installation
2-17.
OL-16264-04