Juniper EX9200 Features Manual page 100

VPLS Feature Guide for EX9200 Switches
82
}
layer-3-only;
layer-4;
}
}
source-mac;
symetric-hash {
complement;
}
}
You can configure one or more of the following options to load-balance using the specified
packet information:
—Include the destination-address MAC information in the hash key
destination-mac
for Layer 2 load balancing.
source-mac —Include the source-address MAC information in the hash key.
—Include the first MPLS label in the hash key. Used for including a one-label
label-1
packet for per-flow load balancing of IPv4 VPLS traffic based on IP information and
MPLS labels.
label-2 —Include the second MPLS label in the hash key. If both
specified, the entire first label and the first 16 bits of the second label are hashed.
—Include the packet's IP payload in the hash key.
payload
ip —Include the IP address of the IPv4 or IPv6 payload in the hash key.
—Include only the Layer 3 information from the packet's IP payload in the
layer-3-only
hash key.
layer-3 —Include Layer 3 information from the packet's IP payload in the hash key.
destination-address-only
hash key.
NOTE: You can include either the
destination-address-only
—Include only the source IP address in the payload in the hash
source-address-only
key.
NOTE: You can include either the
destination-address-only
—Include Layer 4 information from the packet's IP payload in the hash key.
layer-4
—Configure the symmetric hash or symmetric hash complement for
symmetric-hash
configuring symmetrical load balancing on an 802.3ad Link Aggregation Group.
—Include the complement of the symmetric hash in the hash key.
complement
—Include only the destination IP address in the payload in the
source-address-only
statement, not both. They are mutually exclusive.
source-address-only
statement, not both. They are mutually exclusive.
label-1 and label-2
or the
or the
Copyright © 2016, Juniper Networks, Inc.
are