Debug Snmp - Cisco MDS 9000 series Command Reference Manual

debug snmp

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
debug snmp
To enable debugging for the SNMP manager, use the debug snmp command in EXEC mode. To disable
a debug command, use the no form of the command or use the no debug all command to turn off all
debugging.
Syntax Description
all
errors
mts
pkt-dump
trace
pkt
pkthdr
both
tx
rx
node
opcode
sap
numpkt
range
trace-entryexit
trace-stub
Defaults
Disabled.
Command Modes EXEC mode.
Cisco MDS 9000 Family Command Reference
6-112
debug snmp {
all |
errors |
mts {pkt {both | rx [node range | opcode range | sap range] | tx} |
pkthdr {both | rx [numpkt range] | tx}} |
pkt-dump | trace {trace-entryexit | trace-stub}}
no debug snmp {
all |
errors |
mts {pkt {both | rx [node range | opcode range | sap range] | tx} |
pkthdr {both | rx [numpkt range] | tx}} |
pkt-dump | trace {trace-entryexit | trace-stub}}
Enables debugging for all SNMP output.
Enables debugging for SNMP error output.
Enables debugging for SNMP packets and headers.
Enables a packet dump of debug output.
Enables trace level debug output.
Specifies debugging of packets.
Specifies debugging of headers.
Specifies debugging in both the transmit and receive directions.
Specifies debugging in the transmit direction.
Specifies debugging in the receive direction.
Specifies the node for the packets in the receive direction.
Specifies the opcode for the packets in the receive direction.
Specifies the sap for the packets in the receive direction.
Specifies the number of required packets
Specifies the integer range from 1 to 4095.
Specifies trace-level entry or exit debug output.
Specifies trace-level stub debug output.
Chapter 6 Debug Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x