Crypto Map Domain Ipsec (Configuration Mode) - Cisco MDS 9000 series Command Reference Manual

crypto map domain ipsec (configuration mode)

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
crypto map domain ipsec (configuration mode)
To specify an IPsec crypto map and enter IPsec crypto map configuration mode, use the crypto map
domain ipsec command. To delete an IPsec crypto map or a specific entry in an IPsec crypto map, use
the no form of the command.
Syntax Description map-name
seq-number
Defaults None.
Command Modes
Configuration mode.
Command History Release
2.0(x)
Usage Guidelines To use this command, IPsec must be enabled using the crypto ipsec enable command.
The sequence number determines the order in which IPsec crypto map entries are applied.
Examples The following example specifies entry 1 for IPsec crypto map IPsecMap and enters IPsec crypto map
configuration mode.
switch# config terminal
switch(config)# crypto map domain ipsec IPsecMap 1
switch(config-crypto-map-ip)#
The following example deletes an IPsec crypto map entry.
switch# config terminal
switch(config)# no crypto map domain ipsec IPsecMap 1
The following example deletes the entire IPsec crypto map.
switch# config terminal
switch(config)# no crypto map domain ipsec IPsecMap
Cisco MDS 9000 Family Command Reference
4-128
crypto map domain ipsec map-name seq-number
no crypto map domain ipsec map-name [seq-number]
Specifies the map name. Maximum length is 63 characters.
Specifies the sequence number for the map entry. The range is 1 to 65535.
Modification
This command was introduced.
Chapter 4 C Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x