Cisco MDS 9000 series Command Reference Manual page 751

Chapter 16 N Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
The following example configures NASB on the SSM installed in slot 4 with a link to VSAN 10, and
enables a single target LUN that is a Storage Array Controller (Peripheral Device Type = 0x0C) and up
to 10 target LUNs.
switch# config terminal
Enter configuration commands, one per line.
switch(config)# nasb module 4 vsan 10 control multiple
Related Commands Command
ssm enable feature
nasb module
nasb rediscover module
OL-8413-07, Cisco MDS SAN-OS Release 3.x
End with CNTL/Z.
Description
Enables the NASB feature on the Storage Services Module (SSM).
Displays the NASB configuration on the SSM.
Initiates the rediscovery of a target device used for NASB on an SSM
where the feature is enabled.
Cisco MDS 9000 Family Command Reference
nasb module
16-3