Cisco MDS 9000 series Command Reference Manual page 911

Chapter 21 S Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
iscsi slot/port
bay port | ext port
port-channel
channel-number
sup-fc number
rx
traffic-type
initiator
mgmt
target
tx
Defaults Disabled.
Command Modes
SPAN session configuration submode.
Command History Release
1.0(2)
3.1(2)
Usage Guidelines None.
Examples The following example shows how to create a SPAN session, then configures the SPAN traffic at all
sources in VSAN 1.
switch# config terminal
Enter configuration commands, one per line.
switch(config)# span session 1
switch(config-span)# source vsan 1
The following example shows how to configure the SPAN source interface as PortChannel 1.
switch(config-span)# source interface port-channel 1
The following example shows how to configure the SPAN source interface as FC 9/1 with an egress filter
for VSAN 1.
switch(config-span)# source interface fc9/1 tx filter vsan 1
The following example shows how to configure the SPAN source interface as FCIP 51.
switch(config-span)# source interface fcip 51
OL-8413-07, Cisco MDS SAN-OS Release 3.x
(Optional) Configures the iSCSI interface in the specified slot/port on an MDS
9000 Family switch.
(Optional) Configures the Fibre Channel interface on a port on a Cisco Fabric
Switch for HP c-Class BladeSystem or on a Cisco Fabric Switch for IBM
BladeCenter. The range is 0 to 48.
Specifies the PortChannel interface ID. The range is 1 to 128.
Specifies the inband interface, which is 0.
Specifies SPAN traffic in ingress direction.
Configures the SPAN traffic type.
Specifies initiator traffic.
Specifies management traffic.
Specifies target traffic.
Specifies SPAN traffic in egress direction.
Modification
This command was introduced.
Added the interface bay | ext option.
End with CNTL/Z.
Cisco MDS 9000 Family Command Reference
source
21-43